That's what it's generally used for indeed, magnified the structure of this item looked quite fine. I think as long as the battery is fixated, nothing much should happen. Main way of holding the battery down are going to be the velcro straps, I'll only be using two small strips of this stuff to prevent any lateral movement. |
|
Please Log in to join the conversation.
Last edit: by Edou.
|
The following user(s) Liked this: stingray-63
|
|
Please Log in to join the conversation. |
The following user(s) Liked this: stingray-63
|
|
Please Log in to join the conversation. |
The following user(s) Liked this: stingray-63
|
|
Please Log in to join the conversation.
Last edit: by Edou.
|
Getting closer to somewhat of a complete car.
TA03 knuckles - same as TA02 but black of course (don't have special bearings yet)... I was planning on using the short set from this to have four shocks in total : But now realise that package comes with the one piece damper shafts only. Meant for a DT-03, I suspect they will be too long. |
|
Please Log in to join the conversation. |
|
Aren't the same rods than the CC01????? |
Please Log in to join the conversation. |
|
You can use something like black (entretoises)to reduce the length like in the low rider kit for cc01
|
Please Log in to join the conversation. |
Cheers, guys.
But how very odd - just unpacked and compared and they are the exact same length as 50519 after all. So they will go in the (also short) front Super Hornet shocks that are on the Grasshopper - for those pistons (that are not one piece) to go inside the housings I will put on this car. |
|
Please Log in to join the conversation.
Last edit: by Edou.
|