0
0
0
s2sdefault
powered by social2s

 

Please note that rims may react differently because of plastic type and the way you heat them. If you try what this article describe, please always make a test first.

 

Step 1: Use a pot large enough to fit all the wheels you wish to remove tyres from and fill to about half way with water, place onto the stove top and bring to the boil.

andy boil 01

 

Step 2: Place all the wheels into the boiling water and leave for about 3 minutes (of course it doesn’t matter if you leave for longer)

 Make sure that once the water is boiling that you bring it back to a simmer and don't let the wheels touch the bottom to avoid warping the plastic.

andy boil 02

 

Step 3: Remove a wheel from the pot and place onto a towel on the bench top (Safety first, remember to use tongs to handle the wheel from the pot, dishwashing gloves may also be good) Then holding the wheel push down on the sidewall of the tyre (you could use your thumb or a wooden spoon for this) as the glue releases you should hear a crackling sound, if it does not release with minimal to a little effort, then it needs longer on the boil. These tyres were only glued on 1 side, if yours have been glued on both you will need to complete Steps 2 and 3 on each side.

andy boil 03andy boil 04andy boil 06

 

Step 4: Completely remove the tyre from the rim ready for cleaning and reuse. Once you have finished removing all tyres you should find that there is minimal residue on the rims and both the rims and tyres should be reusable if they weren’t damaged to start with.

andy boil 05   andy boil 07

 

Step 5: Clean up the kitchen, wash and put everything you’ve used away . This is a very important step for keeping Wifey happy.

________________________
Written by TB member Andyaus