TOPIC:

stingray-63 wrote:

Bailey is already on board. He only misses 
​​​​​​His captain cap. 

oOh he has his Captains hat, Just has to be on the water to wear it hahaha

Jonny wrote:

I'd be worried about naming a boat something like that, in case of accidental Spoonerisms

stingray-63 wrote:

The only boat on that I wasn't afraid, was my friend's glastron sierra. And we passed a storm on the mediteranean sea. Now, I am scared by boats.

Yeah that would be scary, I would suggest that a boat on a lake is nothing to be scared of though   Our last one was a Vee hull ski boat and my Wife wasn't a fan because it was unstable, This cat fixes that issue 

 

AndyAus wrote:

stingray-63 wrote:

Bailey is already on board. He only misses 
​​​​​​His captain cap. 

oOh he has his Captains hat, Just has to be on the water to wear it hahaha

I'm fan of your son after my grandson Andy. He has a lovely "frimousse"

stingray-63 wrote:

The only boat on that I wasn't afraid, was my friend's glastron sierra. And we passed a storm on the mediteranean sea. Now, I am scared by boats.

Yeah that would be scary, I would suggest that a boat on a lake is nothing to be scared of though   Our last one was a Vee hull ski boat and my Wife wasn't a fan because it was unstable, This cat fixes that issue   
never enough fast for a boat for me. Faster is better on water for me 😥

I'm not saying I have a thing for a trailer project, But it's a tilt model Aparently the floor was crap so I cut it out and got a new one to put in The rest good to go and I will fit my cage to it once painted

 

 

New checker plate floor now in, Prepared the bed frame during the week with rust converter and cold gal. Welded in the factory spots and after the inspector cleared it I cold galed the welds Next fine + no wind day it will get epoxy primed. 



 

 

I love learning new things, After a few online tutorials I found better ratios and techniques for spray painting. Today I epoxy primed the underside of the tilt trailer and the inside of the gates, Very happy with the results

 

Yeahhh looks nice.

completed repairs to the front gate hindges during the week and it warmed up enough this morning to finish epoxy priming the top side 😊 Once hardened off I will test fit / bolt on the cage before flipping it over for the final two top coats underneath.