TOPIC:

AndyAus wrote:

Installed the steering servos for the twin steer setup then cleaned the wheel's and tyres ready to do the lettering Measured up the mounts and drilled the body

　

Those wheels came up a treat Andy.

Al wrote:

AndyAus wrote:

Installed the steering servos for the twin steer setup then cleaned the wheel's and tyres ready to do the lettering Measured up the mounts and drilled the body

　

Those wheels came up a treat Andy.

I agree!

Next part of my Monster truck build is a bull bar I have some extra Hi-Lift bumper trims so I decided to use that as a base, I didn't have the alloy parts and wasn't prepared to pay $40 + post to get some Cut some alloy sheet to the rough shape then using an alloy part from one of my Hi-Lifts as a template I drill the required holes and bolted together before getting my big file out Finished the main shape tonight and now need to get the fine files on to it

Nice work

Finished shaping the alloy pieces, Of course because I need them to fit this chassis I cut the rear section off gave them a brush finish then chamfered the edges. I used what were wheelie bars which I shortened to bolt them to, Next I will make the bars

If needed I have that.
With aloy canty levers