TOPIC:

hi ive just bought a second hand sand scorcher with a sonik 3 esc in it,ive tried it out and it works fine going forward but carnt get it to reverse any ideas or does anyone no where i can get instructions for it
thanks
darren

I've got an instruction sheet for an M.Sonik-4 ... I would have thought the setup procedure is the same, give me a few minutes & I'll scan & post it here

Good luck with it

hi thanks for youre advice unfortunately it dosen,t seem to work any other ideas as i havent a clue
thanks
darren

call the company for advice, or just bite the bullet and buy a new one. mitroniks are cheap enough and provide a good warranty

think i might invest in another seems a shame as i dont think theres anything wrong with this i just dont know how to program it

Try switching the servo reverser on your tranny - I've got a cheapo ESC here that refuses to be programmed for reverse unless the tranny servo reverser is set to reverse... (Discovered that whilst trying to figure out why it wouldn't work with an AP427)