TOPIC:

tamiya 53189

does anybody happen to have this hopup and can give some more info?
thx

edit 05.12.12 Gotcha!

Hoggy put one on his TA02 not too long ago and was nice enough to take a picture of the instructions :



I could mail him if you like more specific details.

The measurement of both the stabilizer holder plates would be nice.
oh and the lengths/thickness of the rod.

oh and try and guess which cars I had in mind.

I'll ask him if he can measure up some things.
Pretty sure you'd want to put them on the DF-01s.
Unless you're hoppin' up a carbon TA02SW.

I've asked Hoggy about the measurements and he confirmed again last week that he'll post the info here.
He just has to find the time to disassemble his TA02 so it may take a little while...

I have the stab on my TA02 SE but no notice. If you need some measure, I can give them you tomorrow. I took it monday for picts. I promised to put themes on tamiyabase.

thx but no hurry, some measurement would be nice, sizes of the bar and the two plates would be great.

Here are some dimension in centimeters:
spacers:0,7cm long 0,65cm ext diameter and 0,3cm inner diameter

stab rod: 4,3x4,3x4,3 cm and 0,15 diam
stab holder(2 damper low ends) 2,7cm
stab ball 0,5cm diam 1,7 cm long
stab holder: 4cm long 1,2cm large 0,5 cm profonder
stab mikey ears :3,45cm long 1,1cm large to mickey ear 0,5 profonder
metal pieces are 0,1 cm """""
If you want other info don't hesitate

EDOU, Here are some picts of my TA02 LE full upgraded.
It has only tam hop up (only motor and wheeles aren't tamiya) (Original hop up wheeles are on an other car). It has the one way.