|
Perfect! Thanks again!! Gonna do some comparisons and post them at some point!!
The following user(s) Liked this: jord001
|
Please Log in to join the conversation. |
|
Looking forward for your conclusions... Saying this taking into account I never found any correspondances information between brushed and brushless maybe because it is slightly more complex than this:
That being said, ratios needs to be considered as well, and with more torque (lower number of turn), you should be able to run longer development, and therefore for a same rpm, you would run faster... If you do videos on this you will ultimately want to measure to speed, acceleration, and battery life, because I'm quite sure the lower number of turns motor consumes more energy I buy kits to built and ru(i)n them
The following user(s) Liked this: stingray-63, jord001
|
Please Log in to join the conversation. |
|
Earlier when you referenced 13.5 turns and 10.T with a fan, was that for the TAMIYA 45057 TBLE-02S ??
The following user(s) Liked this: jord001
|
Please Log in to join the conversation. |
|
Yes. Tble-02s requires a fan when running a 10.5T which is likely to consume around 60A, which the limit of the Tble-02s...
I buy kits to built and ru(i)n them
The following user(s) Liked this: stingray-63, jord001
|
Please Log in to join the conversation. |
|
The following user(s) Liked this: jord001
|
Please Log in to join the conversation. |
I see a Bob Marley van and the other could have a silhouette of a beach theme to go with the orange and blue.
Regards
Lee
The following user(s) Liked this: silvertriple, Ducksnuts
|
|
Please Log in to join the conversation. |
|
@Ducksnut, do yourself a favor, find some Kamtec body shells for the Lunchbox and have fun with paint. Running with a lower gravity center makes it even better
I buy kits to built and ru(i)n them
|
Please Log in to join the conversation. |
|
I vote for the beach blue orange version and your daughter one.
|
Please Log in to join the conversation. |
|
I buy kits to built and ru(i)n them
|
Please Log in to join the conversation. |