TOPIC:

I won't know what I've actually got until I go & look, but I'm sure I've got some chrome plated steel & stainless ones from when I took the bodywork off my kwak 750 turbo. I don't believe in fairings, so they won't be alloy! I'll have a look at stainless button heads whilst I'm at it.
0.6mm wall should be ok (It'll be supported by the internal thread, hopefully). I'll try & find out for sure tomorrow

Had a butchers, no fairing screws small enough, but I did find some M6 A2 stainless button heads to vandalise. they're about 1mm higher in the head & about 3mm shorter in the thread, but they should be ok. Done a set of 4 so they all look the same from whatever side you're looking at. 0.6 wall for the sleeves was fine, it appears I can get away with 0.1 in brass before it goes a bit pete tong...

Fan-smegging-tastic!

If they'll do, I'll get them & 2x ball joints off to you. Had a dig through my TXT spares, but there's nothing clod related left

Badword editing seems to not be as thorough as it might be

That set of wheels on eBay went for 68.99 GBP (+ 4 GBP postage)

That'll buy a lot of cool RC stuff...

Meh that's bad , i need a new set also for my clod... My wife always says my clod has the appearance of a Bulldozer

Cheers, Bram

Jeez, really? When you said they were too much money, I tutted to myself thinking "15 quid's cheap, they usually go for 30-35". I wonder what's going on with Clodbusters then - haven't seen one go for less than 100 quid recently & spares for them are going for looney money. Can't remember the last time I saw a body for one either, which is a nuisance cos I want one. To put this in perspective, there was a complete but tatty Ranger shell went on there sunday evening for 40-odd quid - surely they're more desirable than poxy clod wheels?!

It may have something to do with the fact that the old line was discontinued recently...
I'm not so much into the specifics of these cars though.